08-16-2013, 12:57 PM
OK the part that everyones been waiting for the actual part, well I get to do it all over again the damn patterns a 1/4" too long. and I figure it will be easier to make a new patten then to try an cut this one down.
anyway heres the photos, it has some sand inclusions from where sand washed loose in the gate and one little sand tear that must of fallen loose when the mold was closed. anyway this shows the part clamped up in position but to fit right it needs to be like within 1/8" of the side of the gear.
![[Image: leadscrew-support-0007.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/leadscrew-support-0007.jpg)
DA
anyway heres the photos, it has some sand inclusions from where sand washed loose in the gate and one little sand tear that must of fallen loose when the mold was closed. anyway this shows the part clamped up in position but to fit right it needs to be like within 1/8" of the side of the gear.
![[Image: leadscrew-support-0007.jpg]](http://s1222.photobucket.com/user/Superdave257/media/leadscrew-support-0007.jpg.html)
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!