08-16-2013, 07:15 AM
Hi Dave, been a while since we spoke.
Not interested in another, LOL
I couldn't count the hours put into that in the kitchen, the weather was cold and if I left it in the shed over night it would rust so I brought it inside to do after grinding. Just lucky these days I don't have another half to complain which is one of the benifits.
I looked around at all the pictures I saved of similar lathes over the years and these castings vary a lot, some have more on one side or the other, some have the square hole off set in the center of carriage etc.
Dave
Not interested in another, LOL
I couldn't count the hours put into that in the kitchen, the weather was cold and if I left it in the shed over night it would rust so I brought it inside to do after grinding. Just lucky these days I don't have another half to complain which is one of the benifits.
I looked around at all the pictures I saved of similar lathes over the years and these castings vary a lot, some have more on one side or the other, some have the square hole off set in the center of carriage etc.
Dave