08-16-2013, 12:57 AM
Thanks Tom,
I upgraded some of the pictures as I was wondering why the camera wasn't working that great, then found finger prints from my grandson on the lense, LOL
It was rough milled under the paint bog which I suppose was to help hold it on which it did, so it took a bit to get it to where it is.
I take pride in my machines and my lathe does not look much different from the day I bought it as far as the machined surfaces go. It is a job keeping all looking that way and fighting off rust, thats why I went with clear coat for this.
Dave
I upgraded some of the pictures as I was wondering why the camera wasn't working that great, then found finger prints from my grandson on the lense, LOL
It was rough milled under the paint bog which I suppose was to help hold it on which it did, so it took a bit to get it to where it is.
I take pride in my machines and my lathe does not look much different from the day I bought it as far as the machined surfaces go. It is a job keeping all looking that way and fighting off rust, thats why I went with clear coat for this.
Dave