04-11-2012, 04:52 PM
(04-11-2012, 04:36 PM)aametalmaster Wrote:(04-11-2012, 09:27 AM)pjf134 Wrote: Bob,
The taper part of the bushing has me wondering why it is needed while a chamfer is all that is needed. Was the taper on the bushing on the scrap piece? Good idea otherwise on the bushing.
Paul
The taper is for holes under 1" from like 3/8"-1" it should have all the bases covered...Bob
How do you make sure you are holding the punch at an exact right angle to the work with the tapered nose? It seems like you could have it cocked slightly and your punch mark won't end up exactly where you want it.
Thanks,
Ed