MetalworkingFun Forum › Machining › Projects v
Transfer punches

Thread Modes
Transfer punches
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#8
04-11-2012, 04:36 PM
(04-11-2012, 09:27 AM)pjf134 Wrote: Bob,
The taper part of the bushing has me wondering why it is needed while a chamfer is all that is needed. Was the taper on the bushing on the scrap piece? Good idea otherwise on the bushing.
Paul

The taper is for holes under 1" from like 3/8"-1" it should have all the bases covered...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Transfer punches - by aametalmaster - 04-10-2012, 08:04 PM
RE: Transfer punches - by mikecwik - 04-10-2012, 10:13 PM
RE: Transfer punches - by pjf134 - 04-10-2012, 10:18 PM
RE: Transfer punches - by aametalmaster - 04-11-2012, 03:45 AM
RE: Transfer punches - by f350ca - 04-10-2012, 11:13 PM
RE: Transfer punches - by krv3000 - 04-11-2012, 01:53 AM
RE: Transfer punches - by pjf134 - 04-11-2012, 09:27 AM
RE: Transfer punches - by aametalmaster - 04-11-2012, 04:36 PM
RE: Transfer punches - by EdK - 04-11-2012, 04:52 PM
RE: Transfer punches - by aametalmaster - 04-11-2012, 05:09 PM



Users browsing this thread: 2 Guest(s)