MetalworkingFun Forum › Machining › General Metalworking Discussion v
A screw up in using a slitting saw

Thread Modes
A screw up in using a slitting saw
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#10
08-11-2013, 06:16 PM (This post was last modified: 08-11-2013, 06:17 PM by dallen.)
plumbing supply its what most plumbing supply houses sell.

and the stuff that say's Ridgid on the jug is over priced
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
A screw up in using a slitting saw - by ieezitin - 08-11-2013, 10:00 AM
RE: A SCREW UP IN USING A SLITTING SAW - by TomG - 08-11-2013, 12:21 PM
RE: A SCREW UP IN USING A SLITTING SAW - by TomG - 08-11-2013, 03:38 PM
RE: A SCREW UP IN USING A SLITTING SAW - by EdK - 08-11-2013, 04:51 PM
RE: A SCREW UP IN USING A SLITTING SAW - by dallen - 08-11-2013, 06:16 PM
RE: A SCREW UP IN USING A SLITTING SAW - by TomG - 08-11-2013, 06:52 PM
RE: A screw up in using a slitting saw - by EdK - 08-12-2013, 05:34 AM



Users browsing this thread: 3 Guest(s)