08-11-2013, 05:01 PM
(08-11-2013, 10:56 AM)dallen Wrote: from what I can tell from the photo most of the parts look like die cast aluminum bars with a slot in them and a hole in one end. The fence that goes across the belt appears to be just a bar with a stud in the end.
unless your going to try to duplicate the originals I don't see why some square bars say 7/8 X 7/8 inch wouldn't do the job, the long fence could cause some problems if you were to try to cast it, but it could be done.
I have already started to draw some plans from the pictures in the literature. I have been scaling off of the photographs and the parts list. Probably will have to build from the drawings that way. You are right it is a simple project to make a functional fence and a set of brackets.
M.L.
ml_woy, proud to be a member of MetalworkingFun since Jul 2012.