08-11-2013, 10:56 AM
from what I can tell from the photo most of the parts look like die cast aluminum bars with a slot in them and a hole in one end. The fence that goes across the belt appears to be just a bar with a stud in the end.
unless your going to try to duplicate the originals I don't see why some square bars say 7/8 X 7/8 inch wouldn't do the job, the long fence could cause some problems if you were to try to cast it, but it could be done.
unless your going to try to duplicate the originals I don't see why some square bars say 7/8 X 7/8 inch wouldn't do the job, the long fence could cause some problems if you were to try to cast it, but it could be done.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!