|
Digital Height Gage (almost finished)
|
08-10-2013, 09:52 PM
Chuck, another good material for scribers is music wire, from your local hobby shop. That's what I used. I tapered the ends on a grinder, then heated just the ends with a torch and quenched in oil. I just left it full hard.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Digital Height Gage (almost finished) - by chucketn - 08-10-2013, 07:44 AM
RE: Digital Height Gage (almost finished) - by dallen - 08-10-2013, 07:54 AM
RE: Digital Height Gage (almost finished) - by chucketn - 08-10-2013, 08:00 AM
RE: Digital Height Gage (almost finished) - by dallen - 08-10-2013, 10:00 PM
RE: Digital Height Gage (almost finished) - by Hawkeye - 08-10-2013, 09:52 PM
RE: Digital Height Gage (almost finished) - by TomG - 08-11-2013, 08:22 AM
RE: Digital Height Gage (almost finished) - by chucketn - 08-24-2013, 07:46 AM
RE: Digital Height Gage (almost finished) - by EdK - 08-24-2013, 09:11 AM
|
