MetalworkingFun Forum › Machining › General Metalworking Discussion v
A Harbor Freight Moment

Thread Modes
A Harbor Freight Moment
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#12
08-10-2013, 09:56 AM
I've often wondered about that. It seems like it would be pretty easy to run a finger into a wheel or under a hammer. Yikes'

Are there a lot of sheet metal bashers out there named Stubbs?

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
A Harbor Freight Moment - by TomG - 08-09-2013, 05:09 PM
RE: A Harbor Freight Moment - by EdK - 08-09-2013, 05:29 PM
RE: A Harbor Freight Moment - by Mayhem - 08-09-2013, 08:39 PM
RE: A Harbor Freight Moment - by TomG - 08-09-2013, 09:04 PM
RE: A Harbor Freight Moment - by oldgoaly - 08-09-2013, 09:35 PM
RE: A Harbor Freight Moment - by PixMan - 08-09-2013, 09:40 PM
RE: A Harbor Freight Moment - by oldgoaly - 08-09-2013, 10:27 PM
RE: A Harbor Freight Moment - by Mayhem - 08-09-2013, 10:39 PM
RE: A Harbor Freight Moment - by oldgoaly - 08-09-2013, 10:48 PM
RE: A Harbor Freight Moment - by PixMan - 08-10-2013, 08:03 AM
RE: A Harbor Freight Moment - by DaveH - 08-10-2013, 08:25 AM
RE: A Harbor Freight Moment - by TomG - 08-10-2013, 09:56 AM
RE: A Harbor Freight Moment - by oldgoaly - 08-10-2013, 11:55 AM
RE: A Harbor Freight Moment - by TomG - 08-10-2013, 12:13 PM
RE: A Harbor Freight Moment - by oldgoaly - 08-10-2013, 01:48 PM



Users browsing this thread: 2 Guest(s)