MetalworkingFun Forum › Machining › Projects v
Work holding device

Thread Modes
Work holding device
RobWilson
Unregistered
 
#8
02-18-2012, 02:59 PM
And the clamp bars ,,, not so many machining photos this time LOL , the bars were made from 30mm boiler plate .
[Image: normal_P1040559.jpg]

After lots of milling :)
[Image: normal_P1040636.jpg]
[Image: normal_P1040632.jpg]
[Image: normal_P1040633.jpg]
[Image: normal_P1040626.jpg]

There is still a bit of work to do .


Cheers Rob
Reply
Thanks given by:


Messages In This Thread
Work holding device - by RobWilson - 02-18-2012, 02:07 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:09 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:11 PM
RE: Work holding device - by Highpower - 02-18-2012, 02:24 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:46 PM
RE: Work holding device - by DaveH - 02-18-2012, 02:40 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:52 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:59 PM
RE: Work holding device - by DaveH - 02-18-2012, 03:12 PM
RE: Work holding device - by EdK - 02-18-2012, 04:51 PM
RE: Work holding device - by RobWilson - 02-18-2012, 05:29 PM
RE: Work holding device - by EdK - 02-18-2012, 05:34 PM
RE: Work holding device - by DaveH - 02-18-2012, 05:49 PM
RE: Work holding device - by TOM REED - 02-19-2012, 04:21 PM
RE: Work holding device - by RobWilson - 02-19-2012, 05:29 PM
RE: Work holding device - by TOM REED - 02-19-2012, 08:43 PM
RE: Work holding device - by RobWilson - 02-20-2012, 12:30 PM
RE: Work holding device - by RobWilson - 03-07-2012, 05:56 AM
RE: Work holding device - by EdK - 03-07-2012, 06:18 AM
RE: Work holding device - by RobWilson - 03-07-2012, 11:53 AM
RE: Work holding device - by DaveH - 03-07-2012, 07:51 AM
RE: Work holding device - by RobWilson - 03-07-2012, 12:00 PM
RE: Work holding device - by DaveH - 03-07-2012, 12:08 PM
RE: Work holding device - by Mayhem - 03-07-2012, 05:49 PM



Users browsing this thread: 4 Guest(s)