08-09-2013, 05:30 PM
Hi Dave,
You are correct the 1 degree is not the broaching tool (bit) clearance, it's the holder, that holds the tool bit off axis by 1 degree. (I think
) causes the 'wobble'.
All the ones I have used fitted in the tail stock or the capstan.
Some needed a bit of hefty force as well, the maximum size I'm thinking will be 6mm (1/4") square or hex.
DaveH
You are correct the 1 degree is not the broaching tool (bit) clearance, it's the holder, that holds the tool bit off axis by 1 degree. (I think
) causes the 'wobble'.All the ones I have used fitted in the tail stock or the capstan.
Some needed a bit of hefty force as well, the maximum size I'm thinking will be 6mm (1/4") square or hex.
DaveH