MetalworkingFun Forum › Machining › Welding & Casting v
Ram clamp handle

Thread Modes
Ram clamp handle
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#6
08-08-2013, 02:29 PM
thanks most of the work on that handle was done with a 6 inch block plane, I had misplaced my spokeshave which is what i was going to do the work with since I don't have a belt sander (its on the list of todo's) the handle looks pretty good even though it is a little on the crude side.

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Ram clamp handle - by dallen - 07-29-2013, 01:45 PM
RE: ram clamp handle - by dallen - 07-30-2013, 11:02 AM
RE: ram clamp handle - by EdK - 07-30-2013, 11:44 AM
RE: ram clamp handle - by dallen - 07-30-2013, 12:32 PM
RE: Ram clamp handle - by DaveH - 08-08-2013, 01:21 PM
RE: Ram clamp handle - by dallen - 08-08-2013, 02:29 PM
RE: Ram clamp handle - by dallen - 11-25-2013, 01:57 PM
RE: Ram clamp handle - by awemawson - 11-25-2013, 02:04 PM
RE: Ram clamp handle - by EdK - 11-25-2013, 05:11 PM
RE: Ram clamp handle - by dallen - 11-26-2013, 09:09 AM
RE: Ram clamp handle - by dallen - 11-26-2013, 09:11 AM
RE: Ram clamp handle - by dallen - 08-23-2014, 08:53 AM
RE: Ram clamp handle - by stevec - 08-23-2014, 10:00 AM
RE: Ram clamp handle - by dallen - 08-23-2014, 11:24 AM



Users browsing this thread: 3 Guest(s)