MetalworkingFun Forum › Machining › General Metalworking Discussion v
ER collets

Thread Modes
ER collets
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#14
08-08-2013, 07:46 AM (This post was last modified: 08-08-2013, 07:48 AM by stevec.)
Ed, The Maritool solution would work were it not for the very small "through hole".
Darren, don't worry, I could never ask a buddy to pay attention when I can't. What were we talking about? Rotfl

I've decided to abandon the quest for an ER solution in favour of making a different spindle for the end mill grinder and mounting a 3 jaw chuck on it.
I'll 'splain further, with pics, when I get a round toit.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
ER collets - by stevec - 08-06-2013, 06:55 PM
RE: ER collets - by EdK - 08-06-2013, 06:59 PM
RE: ER collets - by stevec - 08-06-2013, 07:04 PM
RE: ER collets - by Dave J - 08-07-2013, 04:25 AM
RE: ER collets - by Mayhem - 08-07-2013, 05:19 AM
RE: ER collets - by EdK - 08-07-2013, 05:38 AM
RE: ER collets - by Mayhem - 08-07-2013, 06:24 AM
RE: ER collets - by Bill Gruby - 08-07-2013, 07:03 AM
RE: ER collets - by EdK - 08-07-2013, 07:51 AM
RE: ER collets - by stevec - 08-07-2013, 11:58 AM
RE: ER collets - by Bill Gruby - 08-07-2013, 07:00 PM
RE: ER collets - by EdK - 08-08-2013, 05:48 AM
RE: ER collets - by Mayhem - 08-08-2013, 05:50 AM
RE: ER collets - by stevec - 08-08-2013, 07:46 AM



Users browsing this thread: 1 Guest(s)