MetalworkingFun Forum › Machining › Projects v
Transfer punches

Thread Modes
Transfer punches
pjf134 Offline
Sophmore
***
Posts: 62
Threads: 9
Joined: Feb 2012
Location: Bridgeville, Pennsylvania
#7
04-11-2012, 09:27 AM
Bob,
The taper part of the bushing has me wondering why it is needed while a chamfer is all that is needed. Was the taper on the bushing on the scrap piece? Good idea otherwise on the bushing.
Paul
pjf134, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
Transfer punches - by aametalmaster - 04-10-2012, 08:04 PM
RE: Transfer punches - by mikecwik - 04-10-2012, 10:13 PM
RE: Transfer punches - by pjf134 - 04-10-2012, 10:18 PM
RE: Transfer punches - by aametalmaster - 04-11-2012, 03:45 AM
RE: Transfer punches - by f350ca - 04-10-2012, 11:13 PM
RE: Transfer punches - by krv3000 - 04-11-2012, 01:53 AM
RE: Transfer punches - by pjf134 - 04-11-2012, 09:27 AM
RE: Transfer punches - by aametalmaster - 04-11-2012, 04:36 PM
RE: Transfer punches - by EdK - 04-11-2012, 04:52 PM
RE: Transfer punches - by aametalmaster - 04-11-2012, 05:09 PM



Users browsing this thread: 1 Guest(s)