08-07-2013, 05:43 AM
No problem,
Yes the push rod is to adjust it when you raise or lower the table etc.
You adjust the T slot end on the main shaft to get more or less feed, I think 3 teeth per stroke is what the max is.
The pin has no spring and is just gravity fed, you lift it up and turn it a quarter of a turn for netral.
Dave
Yes the push rod is to adjust it when you raise or lower the table etc.
You adjust the T slot end on the main shaft to get more or less feed, I think 3 teeth per stroke is what the max is.
The pin has no spring and is just gravity fed, you lift it up and turn it a quarter of a turn for netral.
Dave