08-06-2013, 10:02 AM
sounds like the pin is worn and catching in both directions.
should look something like this, this is what I made and put in the one I made for the Cinci but the one on my delta works on the same principle
![[Image: 2013-08-06090417.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/2013-08-06090417.jpg)
you will probably have to dismantle it to find whats actually wrong but sounds like the table travel was set to netrual and it has worn so that it will not pull back over the teeth.
should look something like this, this is what I made and put in the one I made for the Cinci but the one on my delta works on the same principle
![[Image: 2013-08-06090417.jpg]](http://s1222.photobucket.com/user/Superdave257/media/2013-08-06090417.jpg.html)
you will probably have to dismantle it to find whats actually wrong but sounds like the table travel was set to netrual and it has worn so that it will not pull back over the teeth.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!