08-05-2013, 07:52 AM
PixMan, I apologize for the poor quality of my pictures, I was never good with a camera and mine is quite old.
I have found or been referred to several descriptions of mic calibration and cleaning. I cleaned the mic with paper between the jaws, closed the mic and the zero does line up. The barrel is smooth, so it does not need adjusting there. I expect to receive my gage block set today and will check the mic on several blocks.
I just wanted to be able to adjust it if necessary.
Chuck
I have found or been referred to several descriptions of mic calibration and cleaning. I cleaned the mic with paper between the jaws, closed the mic and the zero does line up. The barrel is smooth, so it does not need adjusting there. I expect to receive my gage block set today and will check the mic on several blocks.
I just wanted to be able to adjust it if necessary.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.