MetalworkingFun Forum › Machining › Welding & Casting v
Casting partner/mentor needed

Thread Modes
Casting partner/mentor needed
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#9
08-05-2013, 07:38 AM
Thanks, DA. I may take you up on the offer. I'll check out the AA forum, haven't been there for a while.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Casting partner/mentor needed - by chucketn - 08-04-2013, 10:33 AM
RE: Casting partner/mentor needed - by dallen - 08-04-2013, 10:48 AM
RE: Casting partner/mentor needed - by chucketn - 08-04-2013, 10:55 AM
RE: Casting partner/mentor needed - by oldgoaly - 08-04-2013, 11:07 AM
RE: Casting partner/mentor needed - by chucketn - 08-04-2013, 11:34 AM
RE: Casting partner/mentor needed - by dallen - 08-04-2013, 01:24 PM
RE: Casting partner/mentor needed - by chucketn - 08-04-2013, 02:07 PM
RE: Casting partner/mentor needed - by dallen - 08-04-2013, 03:00 PM
RE: Casting partner/mentor needed - by chucketn - 08-05-2013, 07:38 AM
RE: Casting partner/mentor needed - by dallen - 08-05-2013, 08:27 AM
RE: Casting partner/mentor needed - by dallen - 08-05-2013, 08:52 PM



Users browsing this thread: 1 Guest(s)