04-10-2012, 10:18 PM
(04-10-2012, 08:04 PM)aametalmaster Wrote: I make these from scrap and pass them out at work. We always need bigger transfer punches for plates with big holes to mark on blank plates to be drilled. Just use a smaller transfer punch in this bigger pointed bushing to mark the center hole. I have them to 2"...Bob
Bob,
Does the taper part of the bushing fit the hole in the template plate or the O.D. of the bushing? What method do you use for hardening the punch? What is the side hole in the bushing for, or maybe was there in the scrap piece?
Thanks,
Paul
pjf134, proud to be a member of MetalworkingFun Forum since Feb 2012.