first make sure that it is running the right direction, the slow part of the stroke should be when the ram is going out cutting, then fast when it returns, the hammering may be from a wear on the parts where they fit together in the joint that the yoke fits into on the bottom side of the ram.
Nice shaper.
could you take nice close up of the ratchet mech. I'm still hoping to get a photo of the original one that is on my Cinci. but I'm starting to have my doubts of ever seeing a good photo of the original part.
Remember that shapers and an Oil can go hand in hand, and never stand in front when someone goes to turn one on.
Whats with the lawn mower wheel
Nice shaper.
could you take nice close up of the ratchet mech. I'm still hoping to get a photo of the original one that is on my Cinci. but I'm starting to have my doubts of ever seeing a good photo of the original part.
Remember that shapers and an Oil can go hand in hand, and never stand in front when someone goes to turn one on.
Whats with the lawn mower wheel
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!