MetalworkingFun Forum › Machining › Metrology v
Starrett 103-C Adjustment

Thread Modes
Starrett 103-C Adjustment
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#3
08-03-2013, 08:21 PM
Pixman, I'll take a picture of my mic tomorrow. Thank you for your kind offer.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Starrett 103-C Adjustment - by chucketn - 08-03-2013, 06:42 PM
RE: Starrett 103-C Adjustment - by PixMan - 08-03-2013, 07:21 PM
RE: Starrett 103-C Adjustment - by chucketn - 08-03-2013, 08:21 PM
RE: Starrett 103-C Adjustment - by chucketn - 08-04-2013, 09:27 AM
RE: Starrett 103-C Adjustment - by Mayhem - 08-04-2013, 05:06 PM
RE: Starrett 103-C Adjustment - by PixMan - 08-04-2013, 05:19 PM
RE: Starrett 103-C Adjustment - by PixMan - 08-04-2013, 05:31 PM
RE: Starrett 103-C Adjustment - by chucketn - 08-05-2013, 07:52 AM
RE: Starrett 103-C Adjustment - by PixMan - 08-05-2013, 10:13 AM
RE: Starrett 103-C Adjustment - by chucketn - 08-05-2013, 12:39 PM
RE: Starrett 103-C Adjustment - by PixMan - 08-05-2013, 01:35 PM



Users browsing this thread: 1 Guest(s)