Starrett 103-C Adjustment

Thread Modes

Starrett 103-C Adjustment

chucketn Offline

Junior

Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN

08-03-2013, 06:42 PM

I inherited A Starrett 103-C 0-1 micrometer from my late father. It came to me without a case, instructions, or calibration wrench. Does anyone out there have one of these mics that could provide the instructions as to the calibration? I have a gage block set coming in a few days, and will be able to check its accuracy, but would like to be able to adjust it if necessary.
Chuck

Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Starrett 103-C Adjustment - by chucketn - 08-03-2013, 06:42 PM

RE: Starrett 103-C Adjustment - by PixMan - 08-03-2013, 07:21 PM

RE: Starrett 103-C Adjustment - by chucketn - 08-03-2013, 08:21 PM

RE: Starrett 103-C Adjustment - by chucketn - 08-04-2013, 09:27 AM

RE: Starrett 103-C Adjustment - by Mayhem - 08-04-2013, 05:06 PM

RE: Starrett 103-C Adjustment - by PixMan - 08-04-2013, 05:19 PM

RE: Starrett 103-C Adjustment - by PixMan - 08-04-2013, 05:31 PM

RE: Starrett 103-C Adjustment - by chucketn - 08-05-2013, 07:52 AM