A method of tail stock alignment that works pretty well for me.
|
A method of tail stock alignment that works pretty well for me.
|
(07-30-2013, 05:52 AM)Mayhem Wrote: I suppose I'd better make a dog now as well. A good tip I read on another board was to use an electrical grounding clamp, like this. Work great for diameters up to 1.5" (38mm or so). A .25" (about 6mm) diameter piece works for the drive pin. Most home improvement places have them. Well at least in the US anyway, I don't know if such things exist in the wilds of Australia though. 
If it's crazy but it works, it's not crazy.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
A method of tail stock alignment that works pretty well for me. - by marfaguy - 07-26-2013, 08:14 PM
RE: A method of tail stock alignment that works pretty well for me. - by TomG - 07-26-2013, 08:26 PM
RE: A method of tail stock alignment that works pretty well for me. - by Mayhem - 07-29-2013, 07:16 AM
RE: A method of tail stock alignment that works pretty well for me. - by marfaguy - 07-29-2013, 11:53 AM
RE: A method of tail stock alignment that works pretty well for me. - by EdK - 07-29-2013, 05:50 PM
RE: A method of tail stock alignment that works pretty well for me. - by Mayhem - 07-30-2013, 05:52 AM
RE: A method of tail stock alignment that works pretty well for me. - by marfaguy - 07-30-2013, 08:14 PM
|
