A method of tail stock alignment that works pretty well for me.
|
A method of tail stock alignment that works pretty well for me.
|
07-29-2013, 07:16 AM
My tailstock is adjustable but I don't have a tapered spindle bore. Well I do - it starts off a little more than 3" and tapers down to al little less than 3" at the outer end. I suppose I could mount a chunk of steel in the chuck and turn it to a 60* point.
Hunting American dentists since 2015.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
A method of tail stock alignment that works pretty well for me. - by marfaguy - 07-26-2013, 08:14 PM
RE: A method of tail stock alignment that works pretty well for me. - by TomG - 07-26-2013, 08:26 PM
RE: A method of tail stock alignment that works pretty well for me. - by Mayhem - 07-29-2013, 07:16 AM
RE: A method of tail stock alignment that works pretty well for me. - by marfaguy - 07-29-2013, 11:53 AM
RE: A method of tail stock alignment that works pretty well for me. - by EdK - 07-29-2013, 05:50 PM
RE: A method of tail stock alignment that works pretty well for me. - by Mayhem - 07-30-2013, 05:52 AM
RE: A method of tail stock alignment that works pretty well for me. - by marfaguy - 07-30-2013, 08:14 PM
|
