Work holding device
#3
Next a bit of a clean up were the clamp will run .

[Image: normal_P1040468.jpg]
[Image: normal_P1040474.jpg]

And a chamfer on the outer edge ,, sharp edges get damaged easily when knocked .

[Image: normal_P1040477.jpg]
[Image: normal_P1040479.jpg]

Then i decided to surface grinned the base .

[Image: normal_P1040482.jpg]
[Image: normal_P1040486.jpg]

Then clean up the top on the mill .

[Image: normal_P1040487.jpg]

this face was also ground .

[Image: normal_P1040491.jpg]

Thats all the machining done to that :) a few money shots .

[Image: normal_P1040541.jpg]
[Image: normal_P1040513.jpg]
[Image: normal_P1040495.jpg]

And one next to the Keats for comparison .

[Image: normal_P1040546.jpg]

Suppose i better make the clamps now .


Rob
Reply
Thanks given by:


Messages In This Thread
Work holding device - by RobWilson - 02-18-2012, 02:07 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:09 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:11 PM
RE: Work holding device - by Highpower - 02-18-2012, 02:24 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:46 PM
RE: Work holding device - by DaveH - 02-18-2012, 02:40 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:52 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:59 PM
RE: Work holding device - by DaveH - 02-18-2012, 03:12 PM
RE: Work holding device - by EdK - 02-18-2012, 04:51 PM
RE: Work holding device - by RobWilson - 02-18-2012, 05:29 PM
RE: Work holding device - by EdK - 02-18-2012, 05:34 PM
RE: Work holding device - by DaveH - 02-18-2012, 05:49 PM
RE: Work holding device - by TOM REED - 02-19-2012, 04:21 PM
RE: Work holding device - by RobWilson - 02-19-2012, 05:29 PM
RE: Work holding device - by TOM REED - 02-19-2012, 08:43 PM
RE: Work holding device - by RobWilson - 02-20-2012, 12:30 PM
RE: Work holding device - by RobWilson - 03-07-2012, 05:56 AM
RE: Work holding device - by EdK - 03-07-2012, 06:18 AM
RE: Work holding device - by RobWilson - 03-07-2012, 11:53 AM
RE: Work holding device - by DaveH - 03-07-2012, 07:51 AM
RE: Work holding device - by RobWilson - 03-07-2012, 12:00 PM
RE: Work holding device - by DaveH - 03-07-2012, 12:08 PM
RE: Work holding device - by Mayhem - 03-07-2012, 05:49 PM



Users browsing this thread: 4 Guest(s)