07-23-2013, 09:42 PM
Goalythats a nice looking set of lift out tongs.
F350 I did one other piece but did it in my mill with a 1.250 indexable cutter and other then being limited to about .015 depth of cut it cut find, I just need to get the bit figured out so I can get a decent surface on this even though its going to be beat on with a hammer. but yes it cuts pretty nice, I know I don't want one of them chips going down my shirt collar.
anyway heres the new pattern I'm going to try and pour tomorrow hopefully in cast iron just have to see what tomorrow brings
DA
F350 I did one other piece but did it in my mill with a 1.250 indexable cutter and other then being limited to about .015 depth of cut it cut find, I just need to get the bit figured out so I can get a decent surface on this even though its going to be beat on with a hammer. but yes it cuts pretty nice, I know I don't want one of them chips going down my shirt collar.
anyway heres the new pattern I'm going to try and pour tomorrow hopefully in cast iron just have to see what tomorrow brings
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!