07-23-2013, 06:50 PM
Yikes! Now I don't know which way to go with this. Decisions, decisions. 
The wall thickness of the sleeve will be about 1/4" thick. It only needs to be a light press fit since I'll be pinning the sleeve to the aluminum block. The ID of the sleeve needs to be fairly accurate since it's going to accept a MT-2 sleeve that will need to move in and out via a screw on the end. This project is a ways down the road so I have some time to think about it.
Thanks for all of the suggestions and help everyone.
Ed
The wall thickness of the sleeve will be about 1/4" thick. It only needs to be a light press fit since I'll be pinning the sleeve to the aluminum block. The ID of the sleeve needs to be fairly accurate since it's going to accept a MT-2 sleeve that will need to move in and out via a screw on the end. This project is a ways down the road so I have some time to think about it.
Thanks for all of the suggestions and help everyone.
Ed