07-22-2013, 11:35 PM
Greg,
To do it properly you would need a go-no-go thread plug gauge, but one that size would probably cost you $300 or more. The way you did it will work fine. I usually make my gauges to the upper extreme of the tolerance to ensure that the internal thread ends up large enough.
Tom
To do it properly you would need a go-no-go thread plug gauge, but one that size would probably cost you $300 or more. The way you did it will work fine. I usually make my gauges to the upper extreme of the tolerance to ensure that the internal thread ends up large enough.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)