Work holding device
#2
Next off to the mill to clean up the edges of the base .

[Image: normal_P1040435.jpg]

And the slots poked in .
[Image: normal_P1040438.jpg]
[Image: normal_P1040441.jpg]
[Image: normal_P1040443.jpg]

I was toying with the idea of putting rads on the corners of the base ,,, but being lazy i went for chamfers , so over went the table to 45.
[Image: normal_P1040445.jpg]
[Image: normal_P1040448.jpg]
[Image: normal_P1040450.jpg]
[Image: normal_P1040454.jpg]

Next up the slots ,, the job was repositioned and clocked into the edge .
[Image: normal_P1040460.jpg]

I used a 1012 woodruff cutter to mill the slot .

[Image: normal_P1040461.jpg]
[Image: normal_P1040464.jpg]
[Image: normal_P1040467.jpg]
Reply
Thanks given by:


Messages In This Thread
Work holding device - by RobWilson - 02-18-2012, 02:07 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:09 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:11 PM
RE: Work holding device - by Highpower - 02-18-2012, 02:24 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:46 PM
RE: Work holding device - by DaveH - 02-18-2012, 02:40 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:52 PM
RE: Work holding device - by RobWilson - 02-18-2012, 02:59 PM
RE: Work holding device - by DaveH - 02-18-2012, 03:12 PM
RE: Work holding device - by EdK - 02-18-2012, 04:51 PM
RE: Work holding device - by RobWilson - 02-18-2012, 05:29 PM
RE: Work holding device - by EdK - 02-18-2012, 05:34 PM
RE: Work holding device - by DaveH - 02-18-2012, 05:49 PM
RE: Work holding device - by TOM REED - 02-19-2012, 04:21 PM
RE: Work holding device - by RobWilson - 02-19-2012, 05:29 PM
RE: Work holding device - by TOM REED - 02-19-2012, 08:43 PM
RE: Work holding device - by RobWilson - 02-20-2012, 12:30 PM
RE: Work holding device - by RobWilson - 03-07-2012, 05:56 AM
RE: Work holding device - by EdK - 03-07-2012, 06:18 AM
RE: Work holding device - by RobWilson - 03-07-2012, 11:53 AM
RE: Work holding device - by DaveH - 03-07-2012, 07:51 AM
RE: Work holding device - by RobWilson - 03-07-2012, 12:00 PM
RE: Work holding device - by DaveH - 03-07-2012, 12:08 PM
RE: Work holding device - by Mayhem - 03-07-2012, 05:49 PM



Users browsing this thread: 2 Guest(s)