How to Mill a Part That is Too Thin to Mill

Hello There, Guest! Register

Thread Modes

How to Mill a Part That is Too Thin to Mill

TomG Offline

Offline

Alt. Whipping Boy

Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan

The following 1 user Likes TomG's post:
EdK (07-21-2013)

#8

07-21-2013, 07:29 PM

You are missing the point of the whole exercise. What if I needed a piece of unobtanium, .019" thick? It wouldn't be available anywhere so I would have to make it and this is how I would make it. I scrounge as well, but scrounging isn't always an option.

Tom

Reply

« Next Oldest | Next Newest »

Messages In This Thread

How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 06:03 PM

RE: How to Mill a Part That is Too Thin to Mill - by EdK - 07-21-2013, 06:14 PM

RE: How to Mill a Part That is Too Thin to Mill - by oldgoaly - 07-21-2013, 06:32 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 06:45 PM

RE: How to Mill a Part That is Too Thin to Mill - by EdK - 07-21-2013, 06:48 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 06:56 PM

RE: How to Mill a Part That is Too Thin to Mill - by oldgoaly - 07-21-2013, 07:23 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-21-2013, 07:29 PM

RE: How to Mill a Part That is Too Thin to Mill - by EdK - 07-21-2013, 08:17 PM

RE: How to Mill a Part That is Too Thin to Mill - by tekfab - 07-22-2013, 03:38 AM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-22-2013, 06:28 AM

RE: How to Mill a Part That is Too Thin to Mill - by oldgoaly - 07-22-2013, 07:32 AM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-22-2013, 07:48 AM

RE: How to Mill a Part That is Too Thin to Mill - by oldgoaly - 07-22-2013, 08:02 AM

RE: How to Mill a Part That is Too Thin to Mill - by Mayhem - 07-22-2013, 08:29 AM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-22-2013, 08:56 AM

RE: How to Mill a Part That is Too Thin to Mill - by DaveH - 07-22-2013, 12:57 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-22-2013, 01:48 PM

RE: How to Mill a Part That is Too Thin to Mill - by doubleboost - 07-22-2013, 03:59 PM

RE: How to Mill a Part That is Too Thin to Mill - by TomG - 07-22-2013, 04:30 PM

Users browsing this thread: 2 Guest(s)