Keyway Bushing

Thread Modes

Keyway Bushing

aametalmaster Offline

MTLMSTR

Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio

#15

04-09-2012, 03:44 AM

I have one just like that. And people say you can't cut tapered keyways with a broach LOL. I used to borrow my cousins press and all he had was wooden blocks and i didn't notice the pulley sinking in on one side until it was done. Then i finished my press...Bob

Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Keyway Bushing - by aametalmaster - 04-07-2012, 10:47 AM

RE: Keyway Bushing - by Highpower - 04-07-2012, 10:58 AM

RE: Keyway Bushing - by EdK - 04-07-2012, 11:50 AM

RE: Keyway Bushing - by DaveH - 04-07-2012, 11:55 AM

RE: Keyway Bushing - by Highpower - 04-07-2012, 06:01 PM

RE: Keyway Bushing - by stevec - 04-07-2012, 05:12 PM

RE: Keyway Bushing - by DaveH - 04-07-2012, 06:12 PM

RE: Keyway Bushing - by aametalmaster - 04-07-2012, 06:25 PM