Nothing too flash - In fact, downright ugly but it did the job
I made a dual purpose pin wrench and a hook wrench to take apart the spindle pulley bearing assembly for my mill. The pin wrench I made when I initially stripped the mill down failed, as the pins bent. This got put on the shelf until I saw it today.
This time I used roll pins, as they are harder. As there are two nuts that need removing, I used one block of scrap steel and three pins to cover both spacings. The hook wrench is simply a piece of pipe cut in half with a 1/4-20 thread for a screw.
Note the damage done by whoever had this mill previously
I made a dual purpose pin wrench and a hook wrench to take apart the spindle pulley bearing assembly for my mill. The pin wrench I made when I initially stripped the mill down failed, as the pins bent. This got put on the shelf until I saw it today.
This time I used roll pins, as they are harder. As there are two nuts that need removing, I used one block of scrap steel and three pins to cover both spacings. The hook wrench is simply a piece of pipe cut in half with a 1/4-20 thread for a screw.
Note the damage done by whoever had this mill previously
Hunting American dentists since 2015.