Boring a Deep Hole

Thread Modes

Boring a Deep Hole

stevec Offline

69 yr. old senior

Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada

07-16-2013, 07:21 PM

Ed, if I couldn't get 5"+ from my quill on my mill I'd set it up in my 4 jaw on the lathe. Oops! you didn.t mention the length.

Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.

Thanks given by: EdK

« Next Oldest | Next Newest »

Messages In This Thread

Boring a Deep Hole - by EdK - 07-16-2013, 06:23 PM

RE: Boring a Deep Hole - by stevec - 07-16-2013, 07:21 PM

RE: Boring a Deep Hole - by f350ca - 07-16-2013, 07:44 PM

RE: Boring a Deep Hole - by TomG - 07-16-2013, 08:18 PM

RE: Boring a Deep Hole - by PixMan - 07-16-2013, 09:16 PM

RE: Boring a Deep Hole - by EdK - 07-17-2013, 06:09 AM

RE: Boring a Deep Hole - by Mayhem - 07-16-2013, 11:51 PM

RE: Boring a Deep Hole - by EdK - 07-17-2013, 06:01 AM

RE: Boring a Deep Hole - by PixMan - 07-17-2013, 06:23 AM

RE: Boring a Deep Hole - by EdK - 07-17-2013, 06:36 AM

RE: Boring a Deep Hole - by TomG - 07-17-2013, 06:44 AM

RE: Boring a Deep Hole - by EdK - 07-17-2013, 07:16 AM

RE: Boring a Deep Hole - by PixMan - 07-17-2013, 07:00 AM

RE: Boring a Deep Hole - by EdK - 07-17-2013, 07:24 AM

RE: Boring a Deep Hole - by PixMan - 07-17-2013, 07:21 AM

RE: Boring a Deep Hole - by TomG - 07-17-2013, 07:41 AM

RE: Boring a Deep Hole - by EdK - 07-17-2013, 04:38 PM

RE: Boring a Deep Hole - by stevec - 07-19-2013, 12:18 PM

RE: Boring a Deep Hole - by EdK - 07-19-2013, 11:05 AM

RE: Boring a Deep Hole - by EdK - 07-19-2013, 03:42 PM

RE: Boring a Deep Hole - by EdK - 07-23-2013, 04:23 PM

RE: Boring a Deep Hole - by EdK - 07-23-2013, 06:50 PM

RE: Boring a Deep Hole - by dallen - 07-23-2013, 07:06 PM

RE: Boring a Deep Hole - by f350ca - 07-23-2013, 09:19 PM

Users browsing this thread: 2 Guest(s)