07-13-2013, 11:03 PM
So you move from a single tool to a set, that has to be more attractive for marketing future sales 
I had to make up a tool to remove the wheel bearing retaining nut for the front hubs on a 4x4 I own. However, I didn't have a lathe then, so I found a large sacrificial 1/2" drive socket and welded it to a length of pipe that was a suitable diameter. The I welded some round stock to the outside of the pipe, which then located into the holes on the nut. I't looked uglier than a bucket of arse holes but it worked.
I hope to get a demo of this mill in September...
I had to make up a tool to remove the wheel bearing retaining nut for the front hubs on a 4x4 I own. However, I didn't have a lathe then, so I found a large sacrificial 1/2" drive socket and welded it to a length of pipe that was a suitable diameter. The I welded some round stock to the outside of the pipe, which then located into the holes on the nut. I't looked uglier than a bucket of arse holes but it worked.
I hope to get a demo of this mill in September...
Hunting American dentists since 2015.