04-08-2012, 06:25 PM
Dave,
Where do you see the holes from? I have 2 slots for bolts at the bottom of the lathe which were used to bolt it down to the chip tray. The chip tray has only 2 holes in the form of a tube (on on each end). I assume the rubber feet you mentioned are those that have adhesive on one side to stick to the bottom of the flat surface?
Regards,
Wong
Where do you see the holes from? I have 2 slots for bolts at the bottom of the lathe which were used to bolt it down to the chip tray. The chip tray has only 2 holes in the form of a tube (on on each end). I assume the rubber feet you mentioned are those that have adhesive on one side to stick to the bottom of the flat surface?
Regards,
Wong
Wongster
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.