07-09-2013, 12:35 PM
was able to get the gear out and turned it around, now it clears the yoke so the shaper will make a full stroke without hitting anything. need to figure out how to mount the Briggs so I can tighten up the drive belt with some type of over center cam setup.
the electric motor that is on the shaper in the above picture is no good bad bearings or something, wish it ran since its a 3 HP single phase motor.
the electric motor that is on the shaper in the above picture is no good bad bearings or something, wish it ran since its a 3 HP single phase motor.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!