07-07-2013, 04:51 PM
Got some more done on the hammer. I made a stop out of some scrap aluminum to help keep the head from turning and clamped it to the vise jaw.
Next is to make the handle. The handle will be a press fit into the head then I'll drill and tap through the head and handle and install a long set screw to hold them together and to use as a screw to hold the face to the head.
Ed
Next is to make the handle. The handle will be a press fit into the head then I'll drill and tap through the head and handle and install a long set screw to hold them together and to use as a screw to hold the face to the head.
Ed