|
New lathe Chester DB8
|
07-07-2013, 11:16 AM
(07-07-2013, 08:27 AM)stevec Wrote: (I wonder what you meant?) That's OK Steve, so does everyone else.....  I'm not a writer - obviously. It looks like Mick's lathe will do 44TPI (0.4mm) threads. What is that in inches/mm per revolution?  My 7x10 will do 52 TPI and it gives me a near mirror finish on aluminium. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
New lathe Chester DB8 - by Micktoon - 06-28-2013, 06:17 PM
RE: New lathe Chester DB8 - by EdK - 06-28-2013, 06:34 PM
RE: New lathe Chester DB8 - by marfaguy - 06-28-2013, 07:23 PM
RE: New lathe Chester DB8 - by DaveH - 06-29-2013, 05:21 AM
RE: New lathe Chester DB8 - by stevec - 06-29-2013, 05:45 AM
RE: New lathe Chester DB8 - by krv3000 - 07-03-2013, 05:14 PM
RE: New lathe Chester DB8 - by PixMan - 07-05-2013, 08:46 PM
RE: New lathe Chester DB8 - by Mayhem - 07-05-2013, 09:23 PM
RE: New lathe Chester DB8 - by Highpower - 07-05-2013, 11:57 PM
RE: New lathe Chester DB8 - by Mayhem - 07-06-2013, 05:50 AM
RE: New lathe Chester DB8 - by Highpower - 07-06-2013, 07:50 AM
RE: New lathe Chester DB8 - by Mayhem - 07-06-2013, 08:12 AM
RE: New lathe Chester DB8 - by Highpower - 07-06-2013, 09:07 AM
RE: New lathe Chester DB8 - by Mayhem - 07-06-2013, 08:40 PM
RE: New lathe Chester DB8 - by Highpower - 07-06-2013, 09:26 PM
RE: New lathe Chester DB8 - by stevec - 07-07-2013, 08:27 AM
RE: New lathe Chester DB8 - by Highpower - 07-07-2013, 11:16 AM
RE: New lathe Chester DB8 - by krv3000 - 07-07-2013, 05:50 PM
|
