MetalworkingFun Forum › Machinery › Lathes v
New lathe Chester DB8

Thread Modes
New lathe Chester DB8
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#11
07-06-2013, 07:50 AM
If there is no carriage feed, why would it have a lead screw then? 17428

Or are you talking about engaging/disengaging/reversing the lead screw?
I'm not sure of what you are saying. Blush

Mini-lathes have a tumbler gear lever on the rear of the headstock that accomplishes that and would not be visible in that picture. Perhaps that is the case? [Image: spamafote.gif]
Willie
Reply
Thanks given by:


Messages In This Thread
New lathe Chester DB8 - by Micktoon - 06-28-2013, 06:17 PM
RE: New lathe Chester DB8 - by EdK - 06-28-2013, 06:34 PM
RE: New lathe Chester DB8 - by marfaguy - 06-28-2013, 07:23 PM
RE: New lathe Chester DB8 - by DaveH - 06-29-2013, 05:21 AM
RE: New lathe Chester DB8 - by stevec - 06-29-2013, 05:45 AM
RE: New lathe Chester DB8 - by krv3000 - 07-03-2013, 05:14 PM
RE: New lathe Chester DB8 - by PixMan - 07-05-2013, 08:46 PM
RE: New lathe Chester DB8 - by Mayhem - 07-05-2013, 09:23 PM
RE: New lathe Chester DB8 - by Highpower - 07-05-2013, 11:57 PM
RE: New lathe Chester DB8 - by Mayhem - 07-06-2013, 05:50 AM
RE: New lathe Chester DB8 - by Highpower - 07-06-2013, 07:50 AM
RE: New lathe Chester DB8 - by Mayhem - 07-06-2013, 08:12 AM
RE: New lathe Chester DB8 - by Highpower - 07-06-2013, 09:07 AM
RE: New lathe Chester DB8 - by Mayhem - 07-06-2013, 08:40 PM
RE: New lathe Chester DB8 - by Highpower - 07-06-2013, 09:26 PM
RE: New lathe Chester DB8 - by stevec - 07-07-2013, 08:27 AM
RE: New lathe Chester DB8 - by Highpower - 07-07-2013, 11:16 AM
RE: New lathe Chester DB8 - by krv3000 - 07-07-2013, 05:50 PM



Users browsing this thread: 1 Guest(s)