04-08-2012, 12:09 PM
The pulley arbor is keyed as well as the pulley blank so it doesn't slip.
The pointed HSS tool bit shown in the 1st pic cuts the edges but just at the point of the tip. I turn the compound and cut the one side first then turn the compound and cut the other side and hope :) everything is in the center...Bob
The pointed HSS tool bit shown in the 1st pic cuts the edges but just at the point of the tip. I turn the compound and cut the one side first then turn the compound and cut the other side and hope :) everything is in the center...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...