MetalworkingFun Forum › Machining › General Metalworking Discussion v
I make pulleys too.

Thread Modes
I make pulleys too.
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#2
04-08-2012, 11:49 AM (This post was last modified: 04-08-2012, 11:52 AM by DaveH.)
Bob,
So do you cut the 1/4" groove to the full depth first then open up the sides.

Do you have one of those "fancy" tools that cuts the sides for you at the correct angle?
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
I make pulleys too. - by aametalmaster - 04-08-2012, 10:15 AM
RE: I make pulleys too. - by DaveH - 04-08-2012, 11:49 AM
RE: I make pulleys too. - by ETC57 - 04-08-2012, 11:59 AM
RE: I make pulleys too. - by aametalmaster - 04-08-2012, 12:09 PM
RE: I make pulleys too. - by Highpower - 04-08-2012, 05:53 PM
RE: I make pulleys too. - by aametalmaster - 04-08-2012, 07:20 PM
RE: I make pulleys too. - by DaveH - 04-08-2012, 07:27 PM
RE: I make pulleys too. - by Highpower - 04-08-2012, 10:00 PM
RE: I make pulleys too. - by stevec - 04-09-2012, 06:50 AM
RE: I make pulleys too. - by Highpower - 04-09-2012, 07:43 AM



Users browsing this thread: 1 Guest(s)