MetalworkingFun Forum › Machinery › Lathes v
Leveling?

Thread Modes
Leveling?
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#6
04-08-2012, 11:29 AM
Wong,

Just been looking at your lathe are there holes in the lathe to allow you to bolt it down. Also do the instructions say anything about bolting it down, or mounting the lathe
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
Leveling? - by Wongster - 04-08-2012, 10:02 AM
RE: Leveling? - by aametalmaster - 04-08-2012, 10:17 AM
RE: Leveling? - by DaveH - 04-08-2012, 10:57 AM
RE: Leveling? - by Wongster - 04-08-2012, 11:12 AM
RE: Leveling? - by DaveH - 04-08-2012, 11:16 AM
RE: Leveling? - by DaveH - 04-08-2012, 11:29 AM
RE: Leveling? - by Bogstandard - 04-08-2012, 12:05 PM
RE: Leveling? - by DaveH - 04-08-2012, 12:36 PM
RE: Leveling? - by Wongster - 04-08-2012, 01:24 PM
RE: Leveling? - by DaveH - 04-08-2012, 02:04 PM
RE: Leveling? - by Wongster - 04-08-2012, 06:25 PM
RE: Leveling? - by DaveH - 04-08-2012, 07:04 PM
RE: Leveling? - by Wongster - 04-08-2012, 07:32 PM
RE: Leveling? - by DaveH - 04-08-2012, 07:57 PM
RE: Leveling? - by Rickabilly - 09-23-2012, 10:12 AM
RE: Leveling? - by Hopefuldave - 09-23-2012, 06:00 PM
RE: Leveling? - by Wongster - 09-24-2012, 11:33 AM
RE: Leveling? - by Rickabilly - 09-24-2012, 01:12 PM
RE: Leveling? - by stevec - 09-24-2012, 02:56 PM
RE: Leveling? - by Wongster - 09-24-2012, 05:38 PM
RE: Leveling? - by Rickabilly - 09-25-2012, 04:29 AM
RE: Leveling? - by stevec - 09-24-2012, 05:42 PM



Users browsing this thread: 3 Guest(s)