07-03-2013, 02:25 PM
I still question how useful it is on a lathe with a bed that has not been checked for no twist and the twist removed if present. 
Ed
Ed
|
Is .0005 runout in 10" acceptable?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Is .0005 runout in 10" acceptable? - by marfaguy - 06-30-2013, 04:50 PM
RE: Is .0005 runout in 10" acceptable? - by doubleboost - 06-30-2013, 04:56 PM
RE: Is .0005 runout in 10" acceptable? - by EdK - 06-30-2013, 06:02 PM
RE: Is .0005 runout in 10" acceptable? - by marfaguy - 06-30-2013, 06:27 PM
RE: Is .0005 runout in 10" acceptable? - by TomG - 06-30-2013, 08:22 PM
RE: Is .0005 runout in 10" acceptable? - by Sunset Machine - 07-01-2013, 08:41 AM
RE: Is .0005 runout in 10" acceptable? - by PixMan - 07-02-2013, 07:38 PM
RE: Is .0005 runout in 10" acceptable? - by TomG - 07-02-2013, 07:47 PM
RE: Is .0005 runout in 10" acceptable? - by EdK - 07-03-2013, 02:25 PM
RE: Is .0005 runout in 10" acceptable? - by Sunset Machine - 07-04-2013, 11:28 AM
RE: Is .0005 runout in 10" acceptable? - by EdK - 07-04-2013, 03:44 PM
RE: Is .0005 runout in 10" acceptable? - by Sunset Machine - 07-14-2013, 10:38 AM
|
Users browsing this thread: 1 Guest(s)