I make pulleys too.

The following warnings occurred:

Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)

File	Line	Function
/showthread.php	864	errorHandler->error

Hello There, Guest! Register

Thread Modes

I make pulleys too.

aametalmaster Offline

Offline

MTLMSTR

Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio

#1

04-08-2012, 10:15 AM

Lots of them up to 5" from steel and aluminum. Here is a little vid cutting the groove with a 1/4" HSS tool bit. I take a groove right down the middle of the blank then make the 15* angles on the sides...Bob
http://s110.photobucket.com/albums/n86/a...the023.mp4

Attached Files Thumbnail(s)

.jpg

pulley done.jpg (Size: 2.47 KB / Downloads: 109)
.jpg

.jpg

pulley fun.jpg (Size: 34.54 KB / Downloads: 110)

Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...

Reply

« Next Oldest | Next Newest »

Messages In This Thread

I make pulleys too. - by aametalmaster - 04-08-2012, 10:15 AM

RE: I make pulleys too. - by DaveH - 04-08-2012, 11:49 AM

RE: I make pulleys too. - by ETC57 - 04-08-2012, 11:59 AM

RE: I make pulleys too. - by aametalmaster - 04-08-2012, 12:09 PM

RE: I make pulleys too. - by Highpower - 04-08-2012, 05:53 PM

RE: I make pulleys too. - by aametalmaster - 04-08-2012, 07:20 PM

RE: I make pulleys too. - by DaveH - 04-08-2012, 07:27 PM

RE: I make pulleys too. - by Highpower - 04-08-2012, 10:00 PM

RE: I make pulleys too. - by stevec - 04-09-2012, 06:50 AM

RE: I make pulleys too. - by Highpower - 04-09-2012, 07:43 AM

Users browsing this thread: 1 Guest(s)