I have been busy making aluminum QCTP tool holders for those once in a while tools that we hate to take another tool out of its holder to use.
Last night I was making the knurled wheels (matl aluminum) for setting tool height. I drilled a piece of al bar and tapped for the height screw, sectioned off 4 wheels, and chamfered the edges. My question is, can I grind a parting blade with a slight angle on the tip to cut the parted piece clean? How much angle?
Chuck
Last night I was making the knurled wheels (matl aluminum) for setting tool height. I drilled a piece of al bar and tapped for the height screw, sectioned off 4 wheels, and chamfered the edges. My question is, can I grind a parting blade with a slight angle on the tip to cut the parted piece clean? How much angle?
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.