MetalworkingFun Forum › Machining › General Metalworking Discussion v
Free Tools!

Thread Modes
Free Tools!
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#17
07-01-2013, 08:33 PM
(06-30-2013, 09:18 PM)bollie7 Wrote: Tom.
The alignment sleeve should unscrew off the end. They used to be (probably still are) available in a range of sizes to screw onto the end of a std adjustable reamer.

bollie7

I checked and the pilot does unscrew from the reamer and it has a sliding cone on it that apparently helps keep the reamer in line with the hole. Something like this:

[Image: Gasser%20Axle%20Ream%20Kingpins%2004s%20Aug%2009.JPG]

Now all I need is a kingpin to ream...

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Free Tools! - by TomG - 06-28-2013, 10:25 AM
RE: Free Tools! - by EdK - 06-28-2013, 10:40 AM
RE: Free Tools! - by Mayhem - 06-28-2013, 10:50 AM
RE: Free Tools! - by oldgoaly - 06-28-2013, 11:06 AM
RE: Free Tools! - by DaveH - 06-28-2013, 11:44 AM
RE: Free Tools! - by PixMan - 06-28-2013, 04:27 PM
RE: Free Tools! - by TomG - 06-28-2013, 06:35 PM
RE: Free Tools! - by bollie7 - 06-30-2013, 09:18 PM
RE: Free Tools! - by TomG - 07-01-2013, 08:33 PM
RE: Free Tools! - by Tony Wells - 06-28-2013, 11:48 PM
RE: Free Tools! - by Dave J - 07-01-2013, 03:29 AM
RE: Free Tools! - by Mayhem - 07-01-2013, 04:29 AM
RE: Free Tools! - by EdK - 07-01-2013, 05:33 AM
RE: Free Tools! - by Highpower - 07-01-2013, 07:19 AM
RE: Free Tools! - by TomG - 07-01-2013, 08:56 AM
RE: Free Tools! - by DaveH - 07-01-2013, 12:38 PM
RE: Free Tools! - by Dave J - 07-01-2013, 08:26 PM
RE: Free Tools! - by Mayhem - 07-01-2013, 11:41 PM
RE: Free Tools! - by Dave J - 07-02-2013, 03:33 AM
RE: Free Tools! - by Tony Wells - 07-02-2013, 02:07 AM
RE: Free Tools! - by Mayhem - 07-02-2013, 08:38 AM
RE: Free Tools! - by TomG - 07-02-2013, 09:10 AM
RE: Free Tools! - by Rickabilly - 08-23-2013, 09:35 AM



Users browsing this thread: 6 Guest(s)