06-30-2013, 06:02 PM
Rollie's Dad's method is only useful after you've taken any twist out of the lathe bed. As John said, unless there's an obvious problem I'd leave it as is and just use it for awhile.
Ed
Ed
|
Is .0005 runout in 10" acceptable?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Is .0005 runout in 10" acceptable? - by marfaguy - 06-30-2013, 04:50 PM
RE: Is .0005 runout in 10" acceptable? - by doubleboost - 06-30-2013, 04:56 PM
RE: Is .0005 runout in 10" acceptable? - by EdK - 06-30-2013, 06:02 PM
RE: Is .0005 runout in 10" acceptable? - by marfaguy - 06-30-2013, 06:27 PM
RE: Is .0005 runout in 10" acceptable? - by TomG - 06-30-2013, 08:22 PM
RE: Is .0005 runout in 10" acceptable? - by Sunset Machine - 07-01-2013, 08:41 AM
RE: Is .0005 runout in 10" acceptable? - by PixMan - 07-02-2013, 07:38 PM
RE: Is .0005 runout in 10" acceptable? - by TomG - 07-02-2013, 07:47 PM
RE: Is .0005 runout in 10" acceptable? - by EdK - 07-03-2013, 02:25 PM
RE: Is .0005 runout in 10" acceptable? - by Sunset Machine - 07-04-2013, 11:28 AM
RE: Is .0005 runout in 10" acceptable? - by EdK - 07-04-2013, 03:44 PM
RE: Is .0005 runout in 10" acceptable? - by Sunset Machine - 07-14-2013, 10:38 AM
|
Users browsing this thread: 1 Guest(s)