Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck
|
Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck
|
06-29-2013, 03:58 AM
(06-28-2013, 07:39 PM)marfaguy Wrote: The chucks are left hand thread so under normal turning/facing operations the chucks are going Err, no, surely if its left hand thread it will try to loosen itself ? Myfords and Boxfords are right hand threads and try to tighten under normal use so . . . . Mike
tekfab, proud to be a member of MetalworkingFun Forum since Apr 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck - by marfaguy - 06-28-2013, 07:39 PM
Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck - by EdK - 06-28-2013, 08:04 PM
RE: Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck - by tekfab - 06-29-2013, 03:58 AM
RE: Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck - by stevec - 06-29-2013, 05:49 AM
RE: Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck - by Sunset Machine - 06-29-2013, 07:59 AM
RE: Does anybody actually use the Spindle clamp and set screw when mounting a lathe chuck - by marfaguy - 06-30-2013, 04:21 PM
|
