|
setting up in the 4 jaw
|
06-28-2013, 10:03 PM
(06-28-2013, 08:57 PM)marfaguy Wrote: So this would be a gap bed lathe, correct? That's right. Some have an insert that can be used with a smaller chuck and allow the carriage to get closer to the head. My lathe doesn't have an insert but the saddle is large enough that I can get the carriage up to the chuck.
Hunting American dentists since 2015.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
setting up in the 4 jaw - by the artfull-codger - 06-13-2013, 03:24 PM
RE: setting up in the 4 jaw - by EdK - 06-13-2013, 04:28 PM
RE: setting up in the 4 jaw - by stevec - 06-14-2013, 06:12 AM
RE: setting up in the 4 jaw - by DaveH - 06-28-2013, 12:08 PM
RE: setting up in the 4 jaw - by marfaguy - 06-28-2013, 08:57 PM
RE: setting up in the 4 jaw - by Mayhem - 06-28-2013, 10:03 PM
RE: setting up in the 4 jaw - by PeterT - 10-06-2018, 02:58 AM
RE: setting up in the 4 jaw - by the artfull-codger - 10-06-2018, 02:57 PM
RE: setting up in the 4 jaw - by Vinny - 10-06-2018, 09:09 AM
|
